Software Updates
Keeping your Sonar 3D-15 up to date is highly recommended. You can update the software automatically or manually (offline).
Warning
Thermal protection is disabled during software upgrades.
Make sure the Sonar 3D-15 is submerged in water (or otherwise cooled) throughout the update to prevent overheating.
Automatic Software Update
- Connect to the Internet
Connect the Sonar 3D-15’s Ethernet interface (via the I/O card) to a network with internet access.
Note
If you are using a personal computer, you may need to bridge your computer’s network interfaces (e.g., Wi-Fi to Ethernet) so that the Sonar 3D-15 can reach the internet.
-
Access the Sonar GUI
In your web browser, go to: http://[IP_ADDRESS_OF_THE_SONAR]:9000/#/ or navigate to “Advanced → config → Diagnostics (Show) → Firmware upgrade” -
Check and Install
The GUI automatically checks for new software versions. If an update is found, follow the on-screen instructions to install it.
Offline Software Update
-
Get Current Version and Chip ID
In the Sonar GUI, select “Advanced → config → About this Sonar” to note the current software version and the Chip ID. -
Download the Update Package
Visit the update server to locate the correct.wlup
file for your Sonar’s Chip ID. Confirm that the downloaded version is newer than your current version. -
Set System Time (If Needed)
If you encounter an error (e.g.,Failed: Error upgrading: resize: non-zero exit code: exit status 1
), you must set the system time:- Open the Sonar GUI and select Advanced → Config
- Under Time choose use computer time and click save.
-
Upload the Update File
Return to: http://[IP_ADDRESS_OF_THE_SONAR]:9000/#/ Select Software upgrade, choose Manual upload, and then upload the.wlup
file. -
Complete the Upgrade
Wait for the Sonar to finish applying the update. Keep it submerged to avoid overheating.
After completion, the Sonar 3D-15 will reboot with the new software version.
If you have any questions or run into issues, please consult the release notes and check out the Sonar 3D-15 FAQ or contact our support team.